User's Manual

4: Configuration Using Web-Manager
MatchPort b/g™ User Guide 29
Email Configuration
The unit sends an email to multiple recipients when a specific trigger event occurs.
There are three separate triggers, based on any combination of the configurable pins
when selected as user I/O functions. Optionally, use a two-byte serial string to initiate
a trigger. Each trigger is independent of the others. Each condition within an
individual trigger must be met before the unit will send the email.
To configure the MatchPort’s email settings:
1. On the main menu, click Email to open the Email Settings page.
Figure 4-10. Email Settings
2. Configure the following fields:
Server IP Address
Enter the IP address of the mail server.
Server Port
Enter the port number on the email server.
Domain Name
Enter the email server’s domain name.
Unit Name Enter the username used by the MatchPort to send email
messages. Spaces are not permitted.
Recipients
Recipient 1: Email
Address
Enter the email address designated to receive email
notifications.
Recipient 2: Email
Address
Enter an additional email address designated to receive email
notifications.
Trigger Configuration
A trigger event occurs when the unit receives either one or two bytes of a specified
sequence on the serial port, or because of a specified combination of conditions on
the configurable pins.
Set the configurable pins to Active, Inactive, or None. The configurable pins are
disabled if they are all set to None. If both the serial sequence and the configurable
pins are disabled, the trigger is disabled.