User's Manual

4: Configuration Using Web-Manager
MatchPort b/g™ User Guide 22
and Regular is 48 Mhz. The default is Regular.
HTTP Server Port This option allows the configuration of the web server port
number. The valid range is 1-65535. The default HTTP server
port number is 80.
0x77FE Server Port
Not applicable for this product.
MTU Size The Maximum Transmission Unit (MTU) is the largest physical
packet size a network can transmit for TCP and UDP. Enter
between 512 and 1400 bytes. The default is 1400 bytes.
Host List Configuration
The MatchPort scrolls through the host list until it connects to a device listed in the
host list table. After a successful connection, the unit stops trying to connect to any
others. If this connection fails, the unit continues to scroll through the table until the
next successful connection.
The host list supports a minimum of 1 and a maximum of 12 entries. Each entry
contains an IP address and a port number.
Note: The host list is disabled for Manual and Modem Mode. The unit does
not accept a data connection from a remote device when the hostlist option is
enabled.
To configure the MatchPort’s host list:
1. On the main menu, click the Hostlist tab to open the Hostlist Settings page.
Figure 4-6. Hostlist Settings
2. Enter or modify the following fields from the Hostlist Settings page:
Retry Settings
Retry Counter Enter the value for the number of times the MatchPort should
attempt to retry connecting to the host list.
Retry Timeout Enter the duration (in seconds) the MatchPort should abandon
attempting a connection to the host list.