User's Manual

4: Configuration Using Web-Manager
MatchPort b/g™ User Guide 19
enable this feature.
DHCP Host Name Enter the name of the host on the network providing the IP
address.
Note: Disabling BOOTP, DHCP, and Auto-IP (all three checkboxes) is not
advised as the only available IP assignment method will then be ARP or
serial port.
4. Click the OK button when finished.
Static IP Address Configuration
To assign an IP address and its network configuration manually:
1. Click Network from the main menu.
2. Select Use the following IP configuration.
3. Enter the following (as necessary):
IP Address If DHCP is not used to assign IP addresses, enter it manually
in standard decimal-dot notation. The IP address must be set
to a unique value in the network.
Subnet Mask A subnet mask defines the number of bits taken from the IP
address that are assigned for the host part.
Default Gateway The gateway address, or router, allows communication to
other LAN segments. The gateway address should be the IP
address of the router connected to the same LAN segment as
the unit. The gateway address must be within the local
network.
4. Click the OK button when finished.
Ethernet Configuration
If the Network Mode is Wired Only, in addition to the IP configuration, you must
specify the speed and direction of data transmission.