User's Manual

5: Commands and Levels
dns
Enters the DNS level.
email <number>
Enters the configure email level.
exit
Exit from the system
filesystem
Enters the filesystem level.
iperf <params>
Run iperf with command line parameters passed in quoted string.
kill ssh <session>
Kills SSH session with index from "show sessions"
kill telnet <session>
Kills Telnet session with index from "show sessions"
line <line>
Enters the line level.
<line> = number of the line (serial port) to be configured.
ping <host>
Ping destination continuously with 5 second timeout
ping <host> <count>
Ping destination n times with 5 second timeout
ping <host> <count> <timeout>
Ping destination n times with x timeout (in seconds)
reload
Reboot system
reload factory defaults
Reload factory defaults to permanent storage
show
Show system information
show history
Displays the last 20 commands entered during the current CLI
session.
show interfaces
Show interface statistics
show ip sockets
Show UDP/TCP state information
show lines
Show line information
show processes
Show thread runtime information
show sessions
Show active Telnet and SSH Sessions
ssh
Enters the SSH configuration level.
ssh <optClientUsername> <host>
Begin SSH session on network <host>.
The optClientUserName must match an SSH Client: Users con-
figuration entry.
Use "" in optClientUserName to prompt for host username and
password.
ssh <optClientUsername> <host> <port>
Begin SSH session on network <host>:<port>.
The optClientUserName must match an SSH Client: Users con-
figuration entry.
Use "" in optClientUserName to prompt for host username and
password.
ssl
Enters the SSL configuration level.
telnet <host>
Begin telnet session on network <host>.
telnet <host> <port>
Begin telnet session on network <host>:<port>.
trace route <host>
Trace route to destination
trace route <host> <protocol>
Trace route to destination using TCP, ICMP, or UDP
tunnel <line>
Enters the tunnel level.
<line> = number of the tunnel line (serial port) to be configured.
write
Stores the current configuration in permanent memory.
xml
Enters the XML level.
filesystem (filesystem) level commands
cat <file>
Show the contents of a file
cd <directory>
Change the current directory to the specified directory
clrscrn
Clears the screen.
cp <source file> <destination file>
Copy an existing file
PremierWave EN Command Reference 96