User's Manual

5: Commands and Levels
no email connect
Discontinues sending email alerts upon establishing a connect
mode tunnel.
no email disconnect
Discontinues sending email alerts upon closing a connect mode
tunnel.
promote host <number>
Promotes the identified host, exchanging it place with the host
above it,
to adjust the order of the defined hosts.
reconnect time <milliseconds>
Sets the reconnect time value for tunneling connections estab-
lished by the
device in milliseconds.
<milliseconds> = timeout in milliseconds.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current CLI
session.
show status
Displays tunnel connect status.
start character <control>
Sets the connect mode start character.
The character may be input as text, control, decimal, or hex.
A control character has the form <control>C.
A decimal value character has the form \99.
A hex value character has the form 0xFF.
write
Stores the current configuration in permanent memory.
cp (email-cp:16) level commands
clrscrn
Clears the screen.
exit
Exits to the next higher level.
group <text>
Specify a CP group that shall trigger an email.
<text> = configurable pin group.
no group
Disables the trigger to send an email.
no trigger value
Clears the value that shall trigger an email.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the current CLI
session.
trigger value <number>
Specify a value of the CP group that shall trigger an email.
<number> = numeric value to watch for from the CP group. Can
be specified as
hex if prepended with “0x”.
write
Stores the current configuration in permanent memory.
cp (email-cp:15) level commands
clrscrn
Clears the screen.
exit
Exits to the next higher level.
group <text>
Specify a CP group that shall trigger an email.
<text> = configurable pin group.
no group
Disables the trigger to send an email.
no trigger value
Clears the value that shall trigger an email.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the current CLI
session.
trigger value <number>
Specify a value of the CP group that shall trigger an email.
<number> = numeric value to watch for from the CP group. Can
be specified as
hex if prepended with “0x”.
PremierWave EN Command Reference 65