User's Manual

5: Commands and Levels
packing (tunnel-packing:1) level commands
clrscrn
Clears the screen.
default packing mode
Sets to default packing mode, which is "Disable"
default send character
Removes the send character for packing mode.
default threshold
Restores the default threshold.
default timeout
Restores the default packing mode timeout.
exit
Returns to the tunnel level.
no trailing character
Removes the trailing character for packing mode.
packing mode disable
Disables packing. Data is sent to the network when received.
packing mode send character
Sets packing mode to accumulate data and transmit it upon re-
ceiving the
configured send character on the line (serial port).
packing mode timeout
Sets packing mode to accumulate data and transmit it after a
specified
amount of time (timeout).
send character <control>
Sets the send character for packing mode.
The character may be input as text, control, decimal, or hex.
A control character has the form <control>C.
A decimal value character has the form \99.
A hex value character has the form 0xFF.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current CLI
session.
threshold <bytes>
Sets the threshold (byte count). If the queued data reaches this
threshold
then the data will be sent.
<bytes> = number of bytes in the threshold.
timeout <milliseconds>
Sets the timeout value for packing mode in milliseconds.
<milliseconds> = timeout value, in milliseconds.
trailing character <control>
Sets the trailing character for packing mode.
The character may be input as text, control, decimal, or hex.
A control character has the form <control>C.
A decimal value character has the form \99.
A hex value character has the form 0xFF.
write
Stores the current configuration in permanent memory.
password (tunnel-accept-password:3) level commands
clrscrn
Clears the screen.
exit
Exits to the next higher level.
no password
Removes the password so connections will be accepted unchal-
lenged.
password <text>
Sets the password required on the network side of the tunnel to
begin
a connection.
prompt disable
Inhibits any prompting for password on the network side of the
tunnel.
prompt enable
Sets up so a user on the network side of the tunnel will be
prompted for
a password.
show
Shows the current configuration.
show history
Displays the last 20 commands entered during the current CLI
session.
PremierWave EN Command Reference 195