User's Manual

5: Commands and Levels
default incoming connection
Default disables incoming network connections.
default response type
Default uses text type responses.
display remote ip disable
The incoming RING has nothing following it.
display remote ip enable
The incoming RING is followed by the IP address of the caller.
echo commands disable
Does not echo modem commands.
echo commands enable
Echoes modem commands.
echo pluses disable
Does not echo the +++ characters when entering modem com-
mand mode.
echo pluses enable
Echoes the +++ characters when entering modem command
mode.
error unknown commands disable
Returns OK on unknown AT commands.
error unknown commands enable
Returns an error upon unknown AT commands.
exit
Returns to the tunnel level.
incoming connection automatic
Automatically answer incoming network connections.
incoming connection disabled
Disable incoming network connections.
incoming connection manual
Wait for an ATA command before answering an incoming network
connection.
no connect string
Removes optional CONNECT string information for modem emu-
lation.
reassert
Asserts tunnel modem status with current configured values.
response type numeric
Uses numeric type responses.
response type text
Uses text type responses.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current CLI
session.
show status
Displays tunnel modem status.
verbose response disable
Does not send Modem Response Codes.
verbose response enable
Sends Modem Response Codes out on the Serial Line.
write
Stores the current configuration in permanent memory.
packing (tunnel-packing:3) level commands
clrscrn
Clears the screen.
default packing mode
Sets to default packing mode, which is "Disable"
default send character
Removes the send character for packing mode.
default threshold
Restores the default threshold.
default timeout
Restores the default packing mode timeout.
exit
Returns to the tunnel level.
no trailing character
Removes the trailing character for packing mode.
packing mode disable
Disables packing. Data is sent to the network when received.
packing mode send character
Sets packing mode to accumulate data and transmit it upon re-
ceiving the
configured send character on the line (serial port).
packing mode timeout
Sets packing mode to accumulate data and transmit it after a
specified
amount of time (timeout).
send character <control>
Sets the send character for packing mode.
The character may be input as text, control, decimal, or hex.
A control character has the form <control>C.
PremierWave EN Command Reference 193