User's Manual

5: Commands and Levels
<number> = maximum number of HTTP server log entries.
max timeout <seconds>
Sets the maximum time the HTTP server waits when receiving a
request.
<seconds> = maximum timeout value.
no clear counters
Restores the HTTP counters to the aggregate values.
no port
Disables the HTTP Server port.
no secure credentials
Clears the RSA/DSA certificate selection.
no secure port
Disables the HTTP Server SSL port.
port <number>
Sets the port number the HTTP server will use.
<number> = port number.
secure credentials <text>
Selects the RSA/DSA certificates by name for the HTTP server.
secure port <number>
Sets the port number the HTTP server will use over SSL.
<number> = port number.
secure protocols ssl3 disable
Disables the protocol.
secure protocols ssl3 enable
Enables the protocol.
secure protocols tls1.0 disable
Disables the protocol.
secure protocols tls1.0 enable
Enables the protocol.
secure protocols tls1.1 disable
Disables the protocol.
secure protocols tls1.1 enable
Enables the protocol.
show
Displays the current configuration.
show auth
Displays the HTTP server authentication settings.
show history
Displays the last 20 commands entered during the current CLI
session.
show log
Displays the HTTP server log.
show statistics
Displays the HTTP statistics.
state disable
Disables the HTTP server.
state enable
Enables the HTTP server.
write
Stores the current configuration in permanent memory.
icmp (config-icmp) level commands
clrscrn
Clears the screen.
exit
Exits to the configuration level.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current CLI
session.
state disable
Prevents ICMP packets from being sent or received.
state enable
Allows ICMP packets to be sent and received.
write
Stores the current configuration in permanent memory.
if 1 (config-if:eth0) level commands
bootp disable
Disables BOOTP.
bootp enable
Enables BOOTP.
clrscrn
Clears the screen.
default gateway <IP address>
Sets the configurable gateway IP address to the default value.
default mtu
Restores the default Maximum Transmission Unit (MTU) size.
dhcp client id <text>
Sets the DHCP client id.
dhcp disable
Disables DHCP.
dhcp enable
Enables DHCP.
PremierWave EN Command Reference 178