Technical Specs
Table Of Contents
- Important Notice
- Safety and Hazards
- Limitation of Liability
- Contents
- List of Tables
- List of Figures
- 1: Introduction
- 2: Electrical Specifications
- 3: RF Specifications
- 4: Power
- 5: Software Interface
- 6: Mechanical and Environmental Specifica- tions
- 7: Regulatory Compliance and Industry Certifi- cations
- A: Antenna Specification
- B: Design Checklist
- C: Testing
- AT Command Entry Timing Requirement
- Acceptance Testing
- Certification Testing
- Production Testing
- Functional Production Test
- Quality Assurance Testing
- Suggested Testing Equipment
- Testing Assistance Provided by Lantronix, Inc.
- IOT/Operator Testing
- Extended AT Commands for Testing
- D: Packaging
- E: References
- F: Acronyms
Rev 5 May.21
8
41113694
List of Tables
Table 1-1: Supported RF Bands .......................................................................................... 11
Table 1-2: Carrier Aggregation Downlink Combinations ...................................................... 11
Table 1-3: Carrier Aggregation Uplink Combinations ........................................................... 12
Table 1-4: Required Host-Module Connectors ..................................................................... 15
Table 2-1: Host Interface (75-pin) Connections—Module View ........................................... 21
Table 2-2: Power and Ground Specifications ....................................................................... 25
Table 2-3: USB Interfaces ................................................................................................... 25
Table 2-4: SIM Interface Signals ......................................................................................... 27
Table 2-5: Module Control Signals ...................................................................................... 30
Table 2-6: W_DISABLE1#/W_DISABLE2# Usage .............................................................. 31
Table 2-7: Full_Card_Power_Off# and RESET# Usage ...................................................... 33
Table 2-8: Tx Activity Indicator States ................................................................................. 34
Table 2-9: Tx Activity Indicator Characteristics .................................................................... 34
Table 2-10: Antenna Control Signals ................................................................................... 35
Table 3-1: LTE Frequency Bands ........................................................................................ 41
Table 3-2: LTE Bandwidth Support ...................................................................................... 41
Table 3-3: WCDMA Frequency Bands Support ................................................................... 42
Table 3-4: Conducted Rx (Receive) Sensitivity—LTE Bands .............................................. 43
Table 3-5: Conducted Rx (Receive) Sensitivity—UMTS Bands .......................................... 43
Table 3-6: Conducted Tx (Transmit) Power Tolerances ...................................................... 44
Table 3-7: GNSS Specifications .......................................................................................... 44
Table 4-1: Averaged Standby DC Power Consumption ....................................................... 46
Table 4-2: Averaged Call Mode DC Power Consumption .................................................... 47
Table 4-3: Miscellaneous DC Power Consumption .............................................................. 47
Table 4-4: Module Power States ......................................................................................... 48
Table 4-5: Power State Transition Trigger Levels ................................................................ 49
Table 4-6: USB 2.0 Power-On/Off Timing Parameters (Double Enumeration) .................... 51
Table 4-7: USB 2.0 Power-On/Off Timing Parameters (Single Enumeration)...................... 51
Table 4-8: USB 3.0 Power-On/Off Timing Parameters (Single Enumeration)...................... 51
Table 4-9: Dynamic Power Control of SAR Backoff State ................................................... 52










