Technical Specs
Table Of Contents
- Important Notice
- Safety and Hazards
- Limitation of Liability
- Contents
- List of Tables
- List of Figures
- 1: Introduction
- 2: Electrical Specifications
- 3: RF Specifications
- 4: Power
- 5: Software Interface
- 6: Mechanical and Environmental Specifica- tions
- 7: Regulatory Compliance and Industry Certifi- cations
- A: Antenna Specification
- B: Design Checklist
- C: Testing
- AT Command Entry Timing Requirement
- Acceptance Testing
- Certification Testing
- Production Testing
- Functional Production Test
- Quality Assurance Testing
- Suggested Testing Equipment
- Testing Assistance Provided by Lantronix, Inc.
- IOT/Operator Testing
- Extended AT Commands for Testing
- D: Packaging
- E: References
- F: Acronyms
Rev 5 May.21
76
41113694
Product
Technical
Specification
LTE RF Receive Path Test
Note: This procedure segment is performed in Step 12 of the Production Test Procedure on
page 69.
The suggested test procedure that follows uses the parameters in Table 3-4.
Table 3-4:
Test Settings — LTE Receive Path
Band # Frequency
a
(MHz) Band ID Channel
b
1900 MHz B2 1962.0 43 18900
1700 MHz B4 2134.5 42 20175
850 MHz B5 883.5 45 20525
2600 MHz B7 2657.0 35 21100
700 MHz B12 739.5 50 23095
700 MHz B13 753.0 36 23230
850 MHz B14 765 51 23330
1900 MHz B25 1964.5 61 26365
850 MHz B26 878.5 62 26865
2500 MHz B41 2595.0 76 40620
3500 MHz B42 3502.0 77 42590
3700 MHz B43 3702.0 88 44590
3600 MHz B48 3627.0 96 55990
1700 MHz B66 2157.0 83 132322
600 MHz B71 636.5 97 133297
a. Receive frequencies shown are 2 MHz offset from center
b. Channel value used by the !DARCONFIG command (!DARCONFIG uses uplink (Tx) channel at the
center of the corresponding band (rounded down), for both Tx and Rx testing).