Technical Specs
Table Of Contents
- Important Notice
- Safety and Hazards
- Limitation of Liability
- Contents
- List of Tables
- List of Figures
- 1: Introduction
- 2: Electrical Specifications
- 3: RF Specifications
- 4: Power
- 5: Software Interface
- 6: Mechanical and Environmental Specifica- tions
- 7: Regulatory Compliance and Industry Certifi- cations
- A: Antenna Specification
- B: Design Checklist
- C: Testing
- AT Command Entry Timing Requirement
- Acceptance Testing
- Certification Testing
- Production Testing
- Functional Production Test
- Quality Assurance Testing
- Suggested Testing Equipment
- Testing Assistance Provided by Lantronix, Inc.
- IOT/Operator Testing
- Extended AT Commands for Testing
- D: Packaging
- E: References
- F: Acronyms
Rev 5 May.21
63
41113694
Antenna Specification
•
All tests (except isolation/correlation coefficient)—Test the main or diversity antenna
with the other antenna terminated.
•
Any metallic part of the antenna system that is exposed to the outside environment
needs to meet the electrostatic discharge tests per IEC61000-4-2 (conducted
discharge +8kV).
•
The functional requirements of the antenna system are tested and verified while the
embedded module’s antenna is integrated in the host device.
Note: Additional testing, including active performance tests, mechanical, and accelerated life tests
can be discussed with Lantronix, Inc.’ engineering services. Contact your Lantronix, Inc. repre-
sentative for assistance.