Technical Specs
Table Of Contents
- Important Notice
- Safety and Hazards
- Limitation of Liability
- Contents
- List of Tables
- List of Figures
- 1: Introduction
- 2: Electrical Specifications
- 3: RF Specifications
- 4: Power
- 5: Software Interface
- 6: Mechanical and Environmental Specifica- tions
- 7: Regulatory Compliance and Industry Certifi- cations
- A: Antenna Specification
- B: Design Checklist
- C: Testing
- AT Command Entry Timing Requirement
- Acceptance Testing
- Certification Testing
- Production Testing
- Functional Production Test
- Quality Assurance Testing
- Suggested Testing Equipment
- Testing Assistance Provided by Lantronix, Inc.
- IOT/Operator Testing
- Extended AT Commands for Testing
- D: Packaging
- E: References
- F: Acronyms
Rev 5 May.21
13
41113694
Introduction
Physical Features
•
M.2 form factor—WWAN Type 3042-S3-B (in WWAN—USB 3.0 Port
Configuration 2), as specified in [8] PCI Express NGFF (M.2) Electromechanical
Specification Revision 1.0. (Note: Any variations from the specification are detailed in
this document.)
•
Ambient operating temperature range with appropriate heatsinking:
·
Class A (3GPP compliant): -30°C to +70°C
·
Class B (operational, non-3GPP compliant): -40°C to +85°C (reduced operating
parameters required)
Important: The internal module temperature (reported by AT!PCTEMP) must be kept below
100°C. For best performance, the internal module temperature should be kept below 85°C. Proper
mounting, heat sinks, and active cooling may be required, depending on the integrated application.
Application Interface Features
•
USB interface (QMI) for Linux and Android
•
MBIM for Windows 10 and up, and Linux
•
AT command interface ([1] AT Command Set for User Equipment (UE) (Release 6)
(Doc# 3GPP TS 27.007), plus proprietary extended AT commands)
•
Software Development Kits (SDK),including API (Application Program Interface)
functions:
·
Windows 10
·
Linux
•
Support for active antenna control via dedicated antenna control signals
(ANTCTL0:3)
•
Dynamic power reduction support via software and dedicated GPIO (DPR)
•
OMA DM (Open Mobile Alliance Device Management)
•
FOTA (Firmware Over The Air)
Note: OMA DM and FOTA support is operator-dependent.
Module Features
•
LTE / DC-HSPA+ / HSPA+ / HSPA / UMTS (WCDMA) operation
•
Multiple (up to 16) cellular packet data profiles
•
Traditional modem COM port support for AT commands
•
USB suspend/resume
•
Sleep mode for minimum idle power draw
•
SIM application tool kit with proactive SIM commands
•
Enhanced Operator Name String (EONS)
•
Mobile-originated PDP context activation / deactivation
•
Support QoS QCI (3GPP Release 12)
•
Static and Dynamic IP address. The network may assign a fixed IP address or
dynamically assign one using DHCP (Dynamic Host Configuration Protocol).
•
PAP and CHAP support