Technical Specs
Table Of Contents
- Important Notice
- Safety and Hazards
- Limitation of Liability
- Contents
- List of Tables
- List of Figures
- 1: Introduction
- 2: Electrical Specifications
- 3: RF Specifications
- 4: Power
- 5: Software Interface
- 6: Mechanical and Environmental Specifica- tions
- 7: Regulatory Compliance and Industry Certifi- cations
- A: Antenna Specification
- B: Design Checklist
- C: Testing
- AT Command Entry Timing Requirement
- Acceptance Testing
- Certification Testing
- Production Testing
- Functional Production Test
- Quality Assurance Testing
- Suggested Testing Equipment
- Testing Assistance Provided by Lantronix, Inc.
- IOT/Operator Testing
- Extended AT Commands for Testing
- D: Packaging
- E: References
- F: Acronyms
Rev 5 May.21
10
41113694
List of Figures
Figure 2-1: System Block
Diagram
....................................................................................... 18
Figure 2-2: Expanded RF (Transmit) Block Diagram ........................................................... 19
Figure 2-3: Expanded RF (Receive/GNSS) Block Diagram ................................................ 20
Figure 2-4: Recommended Capacitor Placement for USB3.0 Signals ................................. 26
Figure 2-5: SIM Application Interface (applies to both SIM interfaces) ................................. 28
Figure 2-6: SIM Card Contacts (Contact View) .................................................................... 28
Figure 2-7: Recommended WAKE_ON_WAN# Connection ................................................ 31
Figure 2-8: Recommended Wireless Disable Connection .................................................... 32
Figure 2-9: Example LED. ................................................................................................... 34
Figure 2-10: TX_ON State During Transmission .................................................................. 35
Figure 3-1: Module Connectors (Preliminary shield design, subject to change) ................... 36
Figure 4-1: Voltage/Temperature Monitoring State Machines ............................................. 49
Figure 4-2: Signal Timing (Full_Card_Power_Off#, and USB Enumeration) ........................ 50
Figure 6-1: Shield Locations (Top View) .............................................................................. 55
Figure 6-2: Copper Pad Location on Bottom Side of Module ............................................... 56
Figure 4-1: Device Placement in Module Tray ..................................................................... 81
Figure 4-2: Shipping Package ............................................................................................. 82










