Users Manual Part 2

FOX3-2G/3G/4G HARDWARE MANUAL VERSION 2.2.5
This confidential document is a property of Lantronix and may not be copied or circulated without previous permission.
Page 37 of 48
PIN
NAME
DIRECTION
DESCRIPTION
LEVEL
1
MOSI
Output
Master output, slave input
2
USB_V+
Input / Output
Power supply for IO-BOX
+ 3.6 ... + 5.25 V
3
MISO
Input
Master input, slave output
4
DM
Input
USB Data -
Complies to the USB 2.0 specifications
5
CLK
Output
Serial clock
6
DP
Output
USB Data +
Complies to the USB 2.0 specifications
7
Detect USB
Detects the connection to a USB master port.
8
+IN
Input
=+IN (Pin 1 on 8pin connector)
V
+IN
= + 10.8 ... + 32.0 V ; Imax ≤ 1A
9
CS
Output
Chip select
10
GND
-
Ground
Table 10: Pin description of the 10pin mini-USB.
This port can be used to connect the FOX3-2G/3G/4G to the IOBOX-MINI device, which is offered as an accessory to
the FOX3-2G/3G/4G device.
7.5.1. Setting up a USB connection for FOX3-2G/3G/4G
To setup a USB connection with FOX3-2G/3G/4G, do the following steps:
1. Download the USB driver free of charge from our website "FOX3_CDC_driver.zip". Please login first then click
the link below to download the driver (https://www.falcom.de/uploads/media/FOX3_CDC_driver.zip)
2. Connect the FOX3-2G/3G/4G to a free USB port on your PC via your own mini-USB to USB cable and install the
driver. How to install the CDC driver refer to the sub-chapter below.
3. Open a terminal program and send the command $PFAL,MSG.Send.USB,0,"Speed=&(Speed)" from the serial
port (e.g. Serial 1/0) to the FOX3-2G/3G/4G. The answer to this command will be shown on the terminal
program where FOX3-2G/3G/4G is connected to.
7.5.1.1. Installing the CDC driver files for FOX3-2G/3G/4G
To install the FOX3-2G/3G/4G CDC driver, do the following steps:
1. After downloading the driver from our website "FOX3_CDC_driver.zip”. Unzip the contents to a separate
folder.
2. Connect the FOX3-2G/3G/4G to your PC. You will see a message pop up that installation failed.
3. Right-click the popup, and choose "Browse my computer for Driver Software",
Figure 18: Search for USB drivers for FOX3-2G/3G/4G hardware.
4. In the Browse window, navigate to the folder where you extracted the contents of the Zip driver file.
Please note that a double (manual) driver installation is required. In the ZIP file of the FOX3-2G/3G/4G
USB driver you can find the file: "mambo2cdc.inf"