Users Manual Part 2

FOX3-2G/3G/4G HARDWARE MANUAL VERSION 2.2.5
This confidential document is a property of Lantronix and may not be copied or circulated without previous permission.
Page 35 of 48
Figure 14.1: Connecting the battery to the FOX3-2G/3G/4G devices
7.3.1. How to enter the PIN of the inserted SIM card
To insert the PIN of the SIM card follow the steps below (as reference use fig. 15):
1) Install the Workbench software,
2) Connect your FOX3-2G/3G/4G to a free PC COM port via its Promotion Kit and power up your device. How to
set up your FOX3-2G/3G/4G using a Evalboard, is currently in preparation.
3) Start the Workbench software, open a COM Port (1), a Terminal (2) and an Editor (3), then select the COM
port (4) and port settings (115200 bps, 8 Data bits, No Parity bit, 1 Stop bit, None Flow control).
4) Next, click on the Connect icon (II) on the left of the text "Port", to connect to. Connect the Console (5) to the
COM Port and the Editor (6) to the Console on the Connection view. For more details refer to the Workbench
User's Guide.
5) Finally, type the command $PFAL,Cnf.Set,GSM.PIN=xxxx on the the editor (xxxx=PIN of your SIM card) and
then send it to the device by double-click. For more details refer to the manual
“AVL_PFAL_Configuration_Command_Set.pdf”.
Figure 15: Entering the PIN code of the inserted SIM card.