User Manual

Command Reference Show/Monitor/List Commands
12-113
12.52.15 Show/Monitor/List [Telnet] Hosts
Displays either the currently available TCP/IP hosts or the ones that have been defined in the local host
table. Hosts will be displayed along with the method of discovery, such as rwho, a connection, or a host
table look-up. There will be a marking to denote the current nameserver and/or gateway.
The Telnet and Host keywords are interchangeable as well as combinable. You can specify one or the other,
or both, and get the same information.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use the Monitor Hosts command.
Parameters ALL
Displays all known TCP/IP hosts (the default).
hostname
Displays host information for the specified port only. Wildcards are allowed.
Examples
Local> SHOW TELNET HOSTS ALL
Local> LIST HOST MYVAXSTN
See Also Clear/Purge Hosts, page 12-5; Set/Define Telnet Hosts, , page 12-99; Local
Host Table, page 2-10; Local Host Table, page 4-6; Status Displays, page 6-9.
12.52.16 Show/Monitor Users
Displays the current users logged onto the ETS. If a username is given, only information for that user is
shown.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use the Monitor users command.
See Also Set/Define Port Username, page 12-54; Status Displays, page 6-9.
SHOW
MONITOR
LIST





TELNET[] HOSTS
ALL
hostname
SHOW
MONITOR



USERS username[]