User Manual

Command Reference Set/Define SLIP
12-97
12.49.2 Define SLIP
Configures SLIP defaults to be used when a user doesn’t explicitly specify options in the Set SLIP
command, or permanent SLIP connections for particular ports.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Note: Define SLIP Port n implicitly does a Define Port n SLIP Enabled.
Parameters Default
Specifies default SLIP settings to be used for the port. These settings can be
overridden by user-specified options, or when the Force option is Set.
Port
Specifies SLIP options that are intended to affect the port specified with the
portnumparameter, or the current port (when no portnum is given).
Autostart
If enabled, the port will treat all serial input as SLIP packets and will run SLIP
until the port is logged out. The port will then remain idle until reactivated. If
disabled, any defined parameters will be treated as defaults for that particular
port.
DEFINE SLIP
DEFAULT
BROADCAST
FORCE
ENABLED
DISABLED



MTU
mtuval
RFC












PORT portnum[]
AUTOSTART
ENABLED
DISABLED



BROADCAST
FORCE
ENABLED
DISABLED
DEFAULT





IPADDRESS
address
NONE



MTU
DEFAULT
mtuval
RFC


























































