User Manual

Set/Define Service Commands Command Reference
12-90
12.47.14 Set/Define Service PostScript
Determines how the ETS will handle PostScript print jobs. If enabled, the ETS will assume there is a
PostScript printer attached to the service port(s) and try to ensure a job is done before starting another. It
will send a small PostScript job to the printer before the user data to “force” the printer into PostScript mode.
At the end of each job it will wait for the printer to signal that the job was completed. If this is not done,
slower printers may lose jobs as new jobs overwrite a previous job which is still being interpreted. Enabling
PostScript mode is strongly recommended for all PostScript queues.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
See Also Clear/Purge Service, page 12-7; Show/Monitor/List Services, page 12-111;
TCP/Telnet Service Sockets, page 4-14.
12.47.15 Set/Define Service PSConvert
Controls whether the ETS will place a PostScript wrapper around each job. The ETS will try to detect if the
job is already PostScript, in which case it would not add an additional wrapper.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
See Also Clear/Purge Service, page 12-7; Show/Monitor/List Services, page 12-111.
12.47.16 Set/Define Service RTEL
Enables or disables TCP/IP access to the specified service.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
SET
DEFINE



SERVICE ServiceName POSTSCRIPT
ENABLED
DISABLED



SET
DEFINE



SERVICE PSCONVERT
ENABLED
DISABLED



SET
DEFINE



SERVICE ServiceName RTEL
ENABLED
DISABLED


