User Manual
Set/Define Service Commands Command Reference
12-84
Restrictions You must be the privileged user to use this command.
Parameters mask
Enter a mask in numeric IP format. A 0 in any bit position prevents that bit
from passing while a 1 in any bit position allows the bit to pass through.
Examples
Local> SET SERVER SUBNET MASK 255.255.192.0
See Also Set/Define Server IPaddress, page 12-69; Set/Define Server Gateway, page 12-
66; TCP/IP, page 2-7; IP Address, page 4-5.
12.46.46 Set/Define Server UUCP
Determines whether the ETS will use the UUCP handler. If enabled, the ETS will listen to TCP/IP port 540
and attempt to connect any logins there to a service called “UUCP” (typically a serial line with an attached
modem).
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Errors If a UUCP service does not exist, the connection will be closed.
See Also UUCP Support, page 2-14.
12.47 Set/Define Service Commands
12.47.1 Set/Define Service
Creates a local service. A maximum of 16 services may be configured for the ETS. Additional service
parameters are discussed in the following pages.
Note: Services have no default parameters; all options must be configured manually.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
SET
DEFINE
SERVER UUCP
ENABLED
DISABLED
SET
DEFINE
SERVICE ServiceName