User Manual

Command Reference Set/Define Server Commands
12-81
Parameters limit
Enter a value between 0 and 8. The default limit is 4 sessions.
None
Returns the session limit to the default value of 8.
Examples
Local> SET SERVER SESSION LIMIT 2
See Also Set/Define Port Session Limit, page 12-50; Show/Monitor/List Server, page
12-108; Show/Monitor Sessions, page 12-111; Enabling Server-Wide Port
Characteristics, page 4-1.
12.46.41 Define Server Silentboot
Causes the unit to attempt to boot without sending any status messages to the console port (unless there are
errors). By default, the ETS prints status messages.
Note: This command only works with BOOT ROM versions.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
See Also Show/Monitor/List Server, page 12-108; Editing the Boot Parameters, page 3-
7.
12.46.42 Set/Define Server SLIP Password
Configures the password required to start SLIP mode on a port. If the password is not provided on the
command line, the server will prompt the user to enter it.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Parameters passwd
Enter a password of up to 6 alphanumeric characters. Entering a null string
(“ “) disables the password.
SET
DEFINE



SERVER SILENTBOOT
ENABLED
DISABLED



SET
DEFINE



SERVER SLIP PASSWORD[]
passwd
NONE


