User Manual

Set/Define Server Commands Command Reference
12-78
12.46.33 Set/Define Server RARP
Enables or disables querying for a RARP host at system boot time.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
See Also Set/Define Server BOOTP, page 12-63; Editing the Boot Parameters, page 3-
7.
12.46.34 Set/Define Server Reload
Specifies when to reload the code in the flash ROM.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Parameters Always
The ETS will reload flash each time it boots.
Default
The ETS will only reload flash when told to do so (the default).
See Also Initialize, page 12-14; Reloading Operational Software, page 3-7.
12.46.35 Set/Define Server Retransmit Limit
Specifies the number of retries attempted if a network message receives no acknowledgment. This limit may
need to be increased on especially noisy or heavily-used networks.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
SET
DEFINE



SERVER RARP
ENABLED
DISABLED



SET
DEFINE



SERVER RELOAD
ALWAYS
DEFAULT



SET
DEFINE



SERVER RETRANSMIT LIMIT[] RetransLimit