User Manual

Command Reference Set/Define Server Commands
12-75
12.46.27 Set Server NetWare Reset
Instructs the Print ETS module to immediately rescan the network for new connections. This is typically
necessary when setting up queues or print servers using PCONSOLE.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Examples
Local> SET SERVER NETWARE RESET
See Also Set/Define Protocols NetWare Reset, page 12-59; Show/Monitor/List
Protocols, page 12-104.
12.46.28 Set/Define Server Node Limit
Sets the maximum number of LAT service nodes about which the ETS will keep information. If the new
limit is less than the current limit and the service table is full, the number of nodes will be slowly pruned
down to the new value.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Parameters limit
The ETS can be limited to between 0 and 200 hosts. The default is 50 nodes.
None
No limit is imposed.
Examples
Local> SET SERVER NODE LIMIT 6
See Also Show/Monitor/List Server, page 12-108; Node Limit, page 4-3.
12.46.29 Set/Define Server Password Limit
SET SERVER NETWARE RESET
SET
DEFINE



SERVER NODE LIMIT[]
limit
NONE



SET
DEFINE



SERVER PASSWORD LIMIT[]
limit
NONE


