User Manual

Command Reference Set/Define Server Commands
12-71
See Also Show/Monitor/List Server, page 12-108; Reloading Operational Software,
page 3-7; Editing the Boot Parameters, page 3-7.
12.46.19 Set/Define Server Lock
Controls whether or not local users rare permitted to Lock their ports. When a port is locked, the active
session or connection cannot be used until the port is unlocked. This is desirable when you want to leave a
console running, possibly with privileged status enabled, without having to worry about security
considerations.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
See Also Lock, page 12-16; Enabling Server-Wide Port Characteristics, page 4-1;
Locking a Port, page 5-15.
12.46.20 Set/Define Server Login Password
Specifies the password that is used to log into the ETS from a serial port or the network when Port Password
is Enabled. If the password is not given on the command line, the user will be prompted for it; it will not be
displayed when typed.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Parameters passwd
Enter a password of up to 6 alphabetic characters.
Examples
Local> SET SERVER LOGIN PASSWORD
Password> platyp (not echoed)
Verification> platyp (not echoed)
Local>
See Also Set/Define Port Password, page 12-45; Login Password, page 3-9.
SET
DEFINE



SERVER LOCK
ENABLED
DISABLED



SET
DEFINE



SERVER LOGIN PASSWORD[]passwd[]