User Manual

Set/Define Server Commands Command Reference
12-70
See Also Set/Define Server Console, page 12-65; Set/Define Server Subnet Mask, page
12-83; Show/Monitor/List Server, page 12-108; Show/Monitor/List Protocols,
page 12-104; TCP/IP, page 2-7; Dynamic Host Control Protocol (DHCP),
page 2-10.
12.46.17 Set/Define Server Keepalive Timer
Sets the period in seconds between “hello” messages on active, but quiet, LAT sessions.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Parameters time
Enter a number from 10 to 180.
Examples
Local> SET SERVER KEEPALIVE TIMER 30
See Also Show/Monitor/List Server, page 12-108; Server Identification, page 4-3.
12.46.18 Set/Define Server Loadhost
Specifies the TCP/IP host from which the ETS requests its runtime code. For LAT-loading ETSs, this
command has no function.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Parameters Secondary
Allows you to specify a backup loadhost for use when the primary loadhost is
unavailable.
IPaddress
Specify the address in standard numeric format. Specifying “0.0.0.0” as the
address clears the previously-defined loadhost. No text host names can be
used.
Examples
Local> DEFINE SERVER LOADHOST 193.23.71.49
Local> DEFINE SERVER SECONDARY LOADHOST 192.0.1.89
SET
DEFINE



SERVER KEEPALIVE TIMER[]time
SET
DEFINE



SERVER SECONDARY[] LOADHOST IPaddress