User Manual

Set/Define Server Commands Command Reference
12-66
Enables or disables querying for a DHCP host at system boot time.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Errors Configuring an IP address will automatically disable DHCP.
Enabling DHCP will remove the IP address saved in NVR.
See Also Set/Define Server BOOTP, page 12-63; Set/Define Server IPaddress, page 12-
69; Set/Define Server RARP, page 12-78; Dynamic Host Control Protocol
(DHCP), page 2-10; Editing the Boot Parameters, page 3-7.
12.46.10 Set/Define Server Gateway
Specifies the host to be used as a TCP/IP gateway between networks. Packets destined for a different
network will be directed to the gateway for forwarding.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Errors If no gateway is defined, an error message is returned.
Parameters Secondary
If desired, a secondary gateway can be configured for use when the primary
gateway is unavailable.
IPaddress
Enter an IP address in standard numeric format. Specifying “0.0.0.0” as the
address clears any previously-defined setting.
Examples
Local> SET SERVER GATEWAY 192.0.1.27
Local> SET SERVER SECONDARY GATEWAY 192.0.1.10
See Also Set/Define Server Nameserver, page 12-73; Set/Define Server Subnet Mask,
page 12-83; Show/Monitor/List Protocols, page 12-104; TCP/IP, page 2-7;
TCP/IP Server Parameters, page 4-5.
12.46.11 Set/Define Server Groups
See Set/Define Server Service Groups on page 12-80.
SET
DEFINE



SERVER SECONDARY[] GATEWAY IPaddress