User Manual

Set/Define Server Commands Command Reference
12-64
12.46.5 Set/Define Server Buffering
Specifies the size of buffer (in bytes) to use for network connections. The ETS’s default setting should be
sufficient for most cases. The size can be increased for larger data transfers such as file transfers or printing.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Parameters buffersize
Acceptable buffer sizes range from 128 bytes to 4096 bytes.
Defaults ETS4P, ETS8P, and ETS16P: 2048
Other units: 512
Examples
Local> SET SERVER BUFFERING 1024
12.46.6 Set/Define Server Circuit Timer
Specifies the delay between LAT messages transmissions from the ETS to other nodes. This setting should
not need to be changed under normal circumstances, and should never be altered while there are active
sessions.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Parameters TimerValue
Specify a timer value from 30 to 200 milliseconds. The default is 80
milliseconds.
Examples
Local> SET SERVER CIRCUIT TIMER 55
See Also LAT, page 2-5; Server Identification, page 4-3.
SET
DEFINE



SERVER BUFFERING buffersize
SET
DEFINE



SERVER CIRCUIT TIMER[] TimerValue