User Manual

Command Reference Set/Define Server Commands
12-63
12.46.2 Set/Define Server Bootgateway
Specifies a server to send packets to when downloading code so that units can boot without needing proxy
arp on the router. This is not the loadhost—the packets will be addressed to the loadhost, but will be
physically set to the bootgateway host.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
See Also Editing the Boot Parameters, page 3-7.
12.46.3 Set/Define Server BOOTP
Enables or disables querying for a BOOTP host at system boot time.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
See Also Set/Define Server RARP, page 12-78; Editing the Boot Parameters, page 3-7.
12.46.4 Set/Define Server Broadcast
Enables or disables broadcasts from Local mode to the server’s serial ports.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
See Also Broadcast, page 12-4; Set/Define Port Broadcast, page 12-32; Port Messages,
page 5-13.
SET
DEFINE



SERVER BOOTGATEWAY IPaddress
SET
DEFINE



SERVER BOOTP
ENABLED
DISABLED



SET
DEFINE



SERVER BROADCAST
ENABLED
DISABLED


