User Manual

Set/Define Server Commands Command Reference
12-62
Routing
Configures whether the ETS will act as an internal router. If routing is enabled,
the ETS advertises all of its NetWare services as part of an internal network
and itself as a “router” to that network.
Turning routing on enables all frame types. Turning routing off disables all
frame types; you must then enable the single desired frame type using the
Encapsulation option. Routing must be enabled if more than one frame type
is desired.
Examples
Local>> DEFINE PROTOCOLS NETWARE ACCESS LAB_FS4
Local>> DEFINE PROTO NETWARE DSCONTEXT
ou=kiwi.ou=exotic.o=fruit
Local>> DEFINE PROTOCOLS NETWARE DSTREE foodco
Local>> DEFINE PROTOCOLS NETWARE INTERNAL a3cc0850
Local>> DEFINE PROTOCOLS NETWARE LOADHOST LAB_FS4
Local>> DEFINE PROTOCOLS NETWARE PRINTSERVER LAB_FS4
Local>> DEFINE PROTOCOLS NETWARE ENCAPSULATION ETHER_II
DISABLED
See Also Set/Define Protocols NetWare, page 12-59; Set/Define Server NetWare
Loadhost, page 12-74; Set/Define Server NetWare Printserver, page 12-74;
Set/Define Server Software, page 12-82; Show/Monitor/List Protocols, page
12-104; NetWare, page 2-16; NetWare Server Parameters, page 4-4; Node
Limit, page 4-3; Creating NDS Print Queues with PCONSOLE, page 8-3;
Installing a Print Queue Using PCONSOLE, page 8-7.
12.46 Set/Define Server Commands
12.46.1 Set/Define Server Announcements
Governs whether the ETS will send service advertising messages and MOP remote console announcements
over the network.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
SET
DEFINE



SERVER ANNOUNCEMENTS
ENABLED
DISABLED


