User Manual

Command Reference Set/Define Protocols Commands
12-59
Note: Because the LAT license string is stored in NVR, it must be re-entered after
resetting the unit to factory defaults or restoring NVR.
See Also LAT, page 2-5.
12.45.5 Set/Define Protocols NetWare
Enables or disables the NetWare protocol, and configures NetWare-related settings.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Enabled/Disabled can only be configured using the Define command.
Parameters Access
Allows configuration of a list of fileservers that the ETS will contact for print
jobs. By default, only fileservers on the local network will be queried; this
command can be used to add or remove additional fileservers.
SET
DEFINE



PROTOCOLS NETWARE
ENABLED
DISABLED



ACCESS
ALL
fileserver
LOCAL





DSCONTEXT context
DSLICENSE LicenseString
DSTREE treeString
ENCAPSULATION
802_2
ETHER_II
NATIVE
SNAP







ENABLED
DISABLED



INTERNAL [NETWORK] netnum
LOADHOST
fileserver
NONE



POLLnum
PRINTSERVER
pserver
NONE



RESET
RIP
SAP



ENABLED
DISABLED



ROUTING
ENABLED
DISABLED

















































