User Manual

Set/Define Protocols Commands Command Reference
12-58
Parameters TCPKeepalive
Controls whether the ETS will send TCP keepalive messages. It is enabled by
default, and should remain enabled unless you are absolutely sure you want to
disable it.
Timeserver
Controls whether the ETS will send IP daytime request packets. It is enabled
by default.
See Also Set/Define Server IPaddress, page 12-69; Set/Define Server Gateway, page 12-
66; Set/Define Server Loadhost, page 12-70; Set/Define Server Nameserver,
page 12-73; TCP/IP Server Parameters, page 4-5; Installation Guide.
12.45.3 Define Protocols LAN Manager
Enables or Disables the LAN Manager protocol.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
See Also LAN Manager, page 2-4.
12.45.4 Set/Define Protocols LAT
Enables or Disables the LAT protocol, and allows the ETS administrator to enter the string needed to enable
LAT functionality. The license number must be entered before any LAT functionality is available.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Errors Enabled/Disabled parameters must be defined.
LicenseString is not needed for single-port servers.
Parameters LicenseString
The license string, used to enable LAT functionality on the unit, can be
obtained by calling Lantronix.
DEFINE PROTOCOLS LANMAN
ENABLED
DISABLED



SET
DEFINE



PROTOCOLS LAT
ENABLED
DISABLED



LicenseString






