User Manual

Command Reference Set/Define Protocols Commands
12-57
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Errors If the zone specified cannot be confirmed by a router, the command will fail.
Enabled and Disabled must be configured with Define.
Parameters Devicetype
Changes what NBP type is used to advertise the attached printer. The default
is to advertise printers as LaserWriters.
name
Enter the new NBP type enclosed in quotes.
ZoneName
Name of the zone to move the ETS into.
Examples
Local> DEFINE PROTOCOL APPLETALK ZONE “AcctZone”
See Also Show/Monitor/List Protocols, page 12-104; AppleTalk Server Parameters,
page 4-2.
12.45.2 Define Protocols IP
Enables or Disables the IP protocol, and allows configuration of other IP parameters. Some parameters may
be duplicates of Set ETS commands; the functionality is identical. See the Set ETS commands for
descriptions of the parameters not explained here.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Errors Enabled/Disabled parameters must be defined.
SET
DEFINE



PROTOCOLS IP
ENABLED
DISABLED



IPADDRESS address
SECONDARY[]
GATEWAY host
LOADHOST address
NAMESERVER address





TCPKEEPALIVE
ENABLED
DISABLED



TIMESERVER
ENABLED
DISABLED

























