User Manual

Set/Define Port Commands Command Reference
12-54
See Also Show/Monitor/List Ports, page 12-102; Terminal Type, page 5-13.
12.43.41 Set/Define Port Type
Describes the type of device connected to the port.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers are
specified with integers between 1 and the total number of physical ports. Lists
of ports must be separated by commas. Ranges of ports must be separated by
a dash (-).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
ANSI
VT100-compatible devices.
Softcopy
VT100 without clear screen or cursor controls (the default).
Hardcopy
Deleted characters are echoed between backslashes; there is no cursor
movement.
See Also Show/Monitor/List Ports, page 12-102; Other Port Characteristics, page 5-11.
12.43.42 Set/Define Port Username
Specifies a username for the port. When a username is defined, users will not be asked to enter a username
when logging in to the port.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
SET
DEFINE



PORT
PortList
ALL
TYPE
ANSI
SOFTCOPY
HARDCOPY





SET
DEFINE



PORT
PortList
ALL
USERNAME
username
NONE


