User Manual

Set/Define Port Commands Command Reference
12-50
12.43.34 Set/Define Port Session Limit
Limits the number of active sessions on a port. The maximum allowed sessions on any one port cannot
exceed the server session limit (8).
To view the server session limit, enter the Show ETS command.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers are
specified with integers between 1 and the total number of physical ports. Lists
of ports must be separated by commas. Ranges of ports must be separated by
a dash (-).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
limit
Ports can have 0 to 8 sessions. The default limit is 4 sessions.
None
Allows the maximum number of sessions allowed on the server.
See Also Set/Define Server Session Limit, page 12-80;Show/Monitor/List Ports, page
12-102; Show/Monitor/List Server, page 12-108; Configuring Your Port, page
6-2.
12.43.35 Set/Define Port Signal Check
Determines whether or not the port will check for the DSR signal when remote connections are made. If this
feature is enabled, remote connections to the port will not be permitted unless the DSR signal is asserted. If
this command is specified on a parallel port, the parallel status lines will be decoded to determine if the
printer is attached and on-line.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
SET
DEFINE



PORT
PortList
ALL
SESSION LIMIT
limit
NONE



SET
DEFINE



PORT
PortList
ALL
SIGNAL [CHECK]
ENABLED
DISABLED


