User Manual

Set/Define Port Commands Command Reference
12-48
12.43.30 Set/Define Port Printer
Controls whether the ETS will check to make sure the port is online before sending data to it. In the case of
serial ports, online is defined as the presence of the DSR signal.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers are
specified with integers between 1 and the total number of physical ports. Lists
of ports must be separated by commas. Ranges of ports must be separated by
a dash (-).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
12.43.31 Set/Define Port Queue
Determines whether the port will be “queued” when it requests a connection to a LAT service that is busy.
If queueing is enabled, the connection will be accepted in the order in which it was received by the target
node. If queueing is disabled, the connection will be rejected.
Applies To ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers are
specified with integers between 1 and the total number of physical ports. Lists
of ports must be separated by commas. Ranges of ports must be separated by
a dash (-).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
See Also Set/Define Port Security, page 12-49; Show/Monitor/List Ports, page 12-102.
SET
DEFINE



PORT
PortList
ALL
PRINTER
ENABLED
DISABLED



SET
DEFINE



PORT
PortList
ALL
QUEUE
ENABLED
DISABLED


