User Manual

Set/Define Port Commands Command Reference
12-28
12.43.2 Set/Define Port Authorized Groups
Adds (Enabled) or deletes (Disabled) groups from the list of service groups that are accessible to a port. Use
service groups to restrict access to services on a per-port basis; the authorized groups are the only groups a
port can see. When entries are specified without the Enabled/Disabled parameters, they replace the current
group list.
Applies To ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers are
specified with integers between 1 and the total number of physical ports. Lists
of ports must be separated by commas. Ranges of ports must be separated by
a dash (-).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
All/grouplist
Group numbers range from 0 to 255. They can be listed individually (1, 3, 12)
and by range (3-25, 110-112), with individual entries separated by a comma.
The default is group 0 enabled, groups 1-255 disabled.
Examples
Local> SET PORT AUTHORIZED 0,2-5,101
See Also Set Port Groups, page 12-40; Set/Define Server Service Groups, page 12-80;
Show/Monitor/List Ports, page 12-102; Group Numbers, page 5-12.
12.43.3 Set/Define Port Autobaud
Allows a port to detect the incoming baud rate and change its own baud rate to match it at login time. When
Autobaud is set, you may have to press Return twice or more to allow the port to determine the baud rate.
Autobaud must be disabled for Remote and Dynamic port access and for any port that offers a service.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Autobaud cannot be configured for Virtual ports (Port 0).
SET
DEFINE



PORT
PortList
ALL
AUTHORIZED GROUPS[]
ALL
grouplist



ENABLED
DISABLED
SET
DEFINE



PORT
PortList
ALL
AUTOBAUD
ENABLED
DISABLED


