User Manual

Command Reference Set/Define Dialback
12-23
12.38 Set/Define Dialback
Configures the username/command pairs for the dialback handler. Each username is specified with a
command string that is echoed to the serial port after that user logs in. If a modem is connected to the port,
a user can dial into the ETS, enter his username, and then have the ETS log him out and call him back at a
particular phone number.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Parameters username
A text name, up to 20 characters long.
command
A string of text, up to 30 characters long, that will be executed when the user
connects to the ETS.
Examples
Local> SET DIALBACK “robert” “atdt555-1234”
See Also Set/Define Port Dialback, page 12-36; Dialback, page 5-11.
12.39 Set/Define IPsecurity
This command is used to add or change entries in the IP security table. A port number of 0 is used to denote
the virtual (incoming login) ports. Unless noted, IPsecurity features are disabled by default.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
SET
DEFINE



DIALBACK username command
SET
DEFINE



IPSECURITY ADDRESS[] IPaddress
BOTH
INCOMING
OUTGOING
PRINTING
SLIP
ENABLED
DISABLED



PORTS portlist










