User Manual

Command Reference Clear/Purge Commands
12-7
12.7.5 Clear/Purge Protocol NetWare Access
Clears one or more of the currently specified entries in the NetWare access list.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Errors An error is returned if the entry isn’t found or if no entries are configured.
Parameters fileserver
Removes only the specified entry from the NetWare access list.
Examples
Local> PURGE PROTOCOL NETWARE ACCESS ALL
Local> CLEAR PROTO NET ACC LAB_FS4
See Also Set/Define Protocols NetWare Access, page 12-59; Show/Monitor/List
Protocols, page 12-104; NetWare Access Lists, page 4-4; Access Lists, page 8-
1.
12.7.6 Clear/Purge Service
Removes a defined service from the ETS. The login service can not be deleted via the Clear/Purge
commands—you must use Set/Define Server Incoming to remove them.
Applies To EPS4, ETS4P, ETS8, ETS8P, ETS16, ETS16P
Restrictions You must be the privileged user to use this command.
Errors Clear Service fails when there are sessions connected to the service or when
there are connect requests in the service’s queue. These conditions can be
eliminated with the Logout Port and Remove Queue commands.
Parameters Local
Removes the definitions of all local services.
service
Removes the definition of the specified service.
CLEAR
PURGE



PROTOCOL NETWARE ACCESS
ALL
fileserver



CLEAR
PURGE



SERVICE
LOCAL
service


