User Guide

9: Required Labeling on the Outside of the Host
Open-Q 626 SOM Module Certification OEM Integrator Guide 13
9 Required Labeling on the Outside of the Host
9.1 FCC Labeling Requirements on the Outside of the Host
The FCC requires a label on the outside of the host system visible to the end user. Example wording is:
Contains:
FCC ID: 2AFDI-ITCOQ626S
IC: 9049A-ITCOQ626S
The FCC requires a logo signifying emission compliance on the outside of the host system. The OEM
integrator is responsible to perform FCC Part 15 Class B digital emissions testing on the end system with
the radio Module installed. The FCC logo below should not be affixed unless the OEM integrator has
obtained the necessary Part 15 approval, e.g., self-declaration of conformity.
If the host system is approved to FCC Class B digital emissions limits under a grant of certification issued
by a TCB, the FCC ID number shown on the grant should be used on the label instead of the FCC logo
below.
Also see https://www.fcc.gov/logos
.
A certified modular has the option to use a permanently affixed label, or an electronic label (Refer to FCC
KDB 784748 D02 e labeling for e-labelling guidance). All modules without an integrated display on the
module must be labelled with a module’s FCC ID - Section 2.926.
9.2 Industry Canada Labeling Requirements on the Outside of the
Host