Manualshelf

Use Instructions

ManualsBrandsLantronix Canada ManualsElectronics802.11A/B/G/N/AC WiFi + Bluetooth Module
51525354555657585960
PN 10232 Eagle V1.2 Instructions for Use Rev 1.0 Page 55 of 101
5.2.1. Cleaning ECH
Table 19 External Communication Hub Cleaning Instructions
1.
Wear impervious gloves such as latex gloves when handling Intermediate Level Disinfection Wipes.
2.
Before cleaning, ensure the ECH and all components are UNPLUGGED from their power supplies, and
ensure the all power supplies are UNPLUGGED from electrical outlets.
3.
Use at least two new Intermediate Level Disinfection Wipes to clean and remove all visible soil and
debris from all ECH component surfaces including the ECH Display, ECH PC, ECH Pad, ECH Stand, ECH
Power Supplies, and cables.
4.
Thoroughly clean crevices and areas that are difficult to reach. Where required, fold or bunch
Intermediate Level Disinfection Wipes to push into crevices, corners, and areas that are difficult to
reach.
5.
As necessary, use additional Intermediate Level Disinfection Wipes if they become soiled during the
cleaning process.
6.
In a well-lit area, visually inspect (at a distance of approximately 12 inches) the ECH including the ECH
Display, ECH PC, ECH Pad, ECH Stand, ECH Power Supplies, and cables to ensure all surfaces are
clean.
7.
If necessary, repeat the cleaning steps above until the ECH and its components are clean
5.2.2. Disinfecting ECH
Do not continue with disinfecting the ECH including the ECH Display, ECH PC, ECH Pad, ECH Stand, ECH
Power Supplies, and cables unless the cleaning process described in Section 5.2.1 is completed. Effective
disinfection can only be achieved after completing the cleaning process.
Table 20 External Communication Hub Disinfection Instructions
1.
After cleaning, use at least two new Intermediate Level Disinfection Wipes to thoroughly wet ALL
SIDES and surfaces of the ECH including the ECH Display, ECH PC, ECH Pad, ECH Stand, ECH Power
Supplies, and cables.
2.
Thoroughly wipe crevices and areas that are difficult to reach. Where required, fold or bunch
Intermediate Level Disinfection Wipes to push into crevices, corners, and areas that are difficult to
reach.
3.
Use additional Intermediate Level Disinfection Wipes as necessary to ensure ALL SIDES and surfaces
of the ECH including the ECH Display, ECH PC, ECH Pad, ECH Stand, ECH Power Supplies, and cables
have been wet.
4.
Once wet, allow ECH Display, ECH PC, ECH Pad, ECH Stand, ECH Power Supplies, and cables to dry.