Product Info

Intrinsyc Open-Q™ 626 (APQ8053) SOM Module Certification Technical Note 68: OEM Integrator Guide

Rev. 1.1

11.2 Industry Canada Requirements for End User Manual / Installation

Manual

Industry Canada Statements

This device complies with Industry Canada license-exempt RSS standard(s).

Operation is subject to the following two conditions:

(1) This device may not cause interference, and (2) This device must accept any

interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils

radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:

(1) l’appareil ne doit pas produire de brouillage;

(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le

brouillage est susceptible d’en compromettre le fonctionnement.

This radio transmitter (IC: 9049A-ITCOQ626S/ Open-Q

626 SOM) has been approved by

Industry Canada to operate with the antenna types listed below with the maximum

permissible gain indicated. Antenna types not included in this list, having a gain greater than

the maximum gain indicated for that type, are strictly prohibited for use with this device.

The required antenna impedance is 50 ohms.

Le présent émetteur radio (IC: 9049A-ITCOQ626S/ Open-Q

626 SOM) a été approuvé

par Industrie Canada pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant

un gain admissible maximal. Les types d'antenne non inclus dans cette liste, et dont le gain

est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de

l'émetteur. L’impédance d’antenne requise est de 50 ohms.

Antenna Information:

Model

Type

Connector

Peak Gain (dBi)

FXP.830.07.0100c 2.4/5 GHz Dipole

Antenna w/U.FL cable, 100mm

Dipole

U.FL

2.4~2.5GHz: 3.32

4.9~5.8GHz: 6.11

(Notice for 5GHz and/or when co-located with 5GHz transmitters, the following

statements should be provided for user information.)

Caution:

(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce

the potential for harmful interference to co-channel mobile satellite systems;

(ii) the maximum antenna gain permitted for devices in the bands 5250-5350 MHz and

5470-5725 MHz shall comply with the e.i.r.p. limit; and