Product Info
Table Of Contents
- 1 Introduction
- 2 Applicable Module
- 3 Additional Regulatory Conformance Testing and/or Submissions Required by the Integrator
- 4 Compliant/Allowable Tx Power Settings
- 5 Allowable Antennas to use with the Radio Module
- 6 Antenna Placement inside the Host System and RF Safety
- 7 Simultaneous Transmission with other Integrated or Plug-in Radios
- 8 Module May Not Be Installed by End Users
- 9 Required Labeling on the Outside of the Host
- 10 Required Labeling on the Module
- 11 Required Regulatory Wording for User Manual/Installation Manual
- 12 OEM Integrator Checklist
Title
Date
Originated
15-Nov-
182015
Revision:
C
INTRINSYC TECHNOLOGIES
CORP.
Doc #: ITCNFA324-IG-001
Date Revised:
30-Nov-2018
4
Intrinsyc – Confidential Information
installed. The FCC logo below should not be affixed unless the OEM integrator has obtained the necessary Part 15
approval, e.g., self-declaration of conformity.
If the host system is approved to FCC Class B digital emissions limits under a grant of certification issued by a
TCB, the FCC ID number shown on the grant should be used on the label instead of the FCC logo below.
Also see https://www.fcc.gov/logos.
European Community R&TTE 9.2
The European Community R&TTE Directive requires the CE Marking shown below on the outside of the host AND
on the outside of the shipping container/packaging.
For 2.4 GHz
For 5 GHz or 2.4 GHz = 5 GHz dual bands
The European Community R&TTE Directive also requires the following note to consumers on the outside of the
shipping container/packaging:
Important Notice: This product is a Radio
LAN device operating in the 2.4 & 5 GHz
bands (or 2.4GHz band) for Home and
Office use in the E.E.A.
AT
BE
CH
CY
CZ
DE
DK
ES
FI
FR
GB
GR
EE
HU
IT
IE
IS
LI
LT
LU
LV
MT
NL
NO
PL
PT
SE
SI
SK