Product Info

Title
Date
Originated
15-Nov-
182015
Revision:
C
INTRINSYC TECHNOLOGIES
CORP.
Doc #: ITCNFA324-IG-001
Date Revised:
30-Nov-2018
3
Intrinsyc – Confidential Information
• When transmitting antennae are installed in the display section of notebook/netbook/laptops, the display
section shall not have metallic components and material that can influence or change the operating and RF
exposure characteristics of the antennae.
• The separation between the main and aux antennae must be at least 3 cm.
• The transmitter module may not be co-located with any other transmitter or antenna.
• SAR evaluation is required if the separation distance between the user or bystanders and the device is less
than or equal to 20 cm.
Where one or more of the conditions above cannot be met for a particular host system, additional testing is required
to secure the necessary certifications for the system.
Note: These restrictions do not apply to receive-only antenna.
7 Simultaneous Transmission with other Integrated or Plug-in Radios
The FCC imposes conditions and limitations when additional radio(s) are co-located in the same host system as the
Module with capability to transmit simultaneously. Co-locating other radios such as an integrated or plug in
Wireless WAN/cellular radio with the Module requires additional evaluation and possibly submission for
authorization from the FCC.
Because the rules are highly dependent on the characteristics of the particular radios that are co-located and
simultaneously transmitting, the OEM integrator should seek guidance from a knowledgeable test lab or consultant
to determine if additional testing and FCC certification is required. In this case, failure to evaluate and follow the
required FCC procedures will invalidate the FCC certification of the Module and end system.
8 Module May Not Be Installed by End Users
FCC rules require this Module to be installed in host systems at the factory by the OEM integrator. Thus, end users
of the system my not install the Module. Therefore, the host product user instructions must not advise the end user
on how to access or remove the Module. Additional FCC authorization/filing is needed to allow end user installation
of the radio modules.
If modules are provided to the end users for installation in the host, a two-way authentication protocol is required to
limit the module to operate only with the authorized host system.
9 Required Labeling on the Outside of the Host
FCC 9.1
The FCC requires a label on the outside of the host system visible to the end user. Example wording is:
Contains:
FCC ID: 2AFDI-ITCNFA324
IC: 9049A-ITCNFA324
The FCC requires a logo signifying emission compliance on the outside of the host system. The OEM integrator is
responsible to perform FCC Part 15 Class B digital emissions testing on the end system with the radio Module