Specifications

Page | 13 516041-1118
VIALMIX®RFID CALIBRATION AND REPLACEMENT PROCEDURES
No calibration is required for VIALMIX®RFID. Once powered on, VIALMIX®RFID will display the following when ready for
use:
If VIALMIX®RFID is not functioning properly, contact Lantheus Medical Imaging (see page 15) to determine if a
replacement unit is required.
ELECTRICAL SAFETY AND ELECTROMAGNETIC COMPATIBILITY (EMC)
VIALMIX®RFID has been tested for electrical safety and Electromagnetic Compatibility and found to be in compliance with
the following standards:
IEC 60601-1 – General Safety
IEC 60601-1-2 – Electromagnetic Compatibility
FCC Part 15B – Unintentional Radiator
FCC Part 15C – Intentional Radiator
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
EMC CLASSIFICATION
VIALMIX®RFID is classified as Class A equipment as defined by FCC, CISPR-11, and 60601-1-2. VIALMIX®RFID is intended
for professional use only in a hospital or clinical setting.
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.