User's Manual

AP-952X Industrial Wall-mounted Wireless-N/BG AP/Bridge
User's Manual
18
Chapter 4. AP Mode Configuration
When AP mode is activated, the system can be configured as an Access Point. This section provides information in
configuring the AP mode with graphical illustrations. AP-952X provides functions as stated below where they can be
configured via a user-friendly web based interface.
OPTION System Wireless Utilities Status
Operating Mode General Setup Profile Setting Overview
LAN Advanced Setup Firmware Upgrade Extra Info
Management Virtual AP Setup Network Utility Event Log
Time Server Associated Clients Reboot
Function
SNMP WDS Status
Table 4-1: AP Mode Functions
After finishing the configuration of the settings, please click Save button and pay attention to see if a
Reboot message appears on the screen. If such message appears, system must be restarted to allow the
settings to take effect. All online users will be disconnected during restart.
AP-952X supports two operation modes; AP mode and WDS mode. Click System -> Operating Mode, the
administrator can set the desired mode via this page, and then configure the system according to their deployment
needs.
 AP Mode : Check AP Mode button to enable AP mode, and then click “Save&Reboot” to activate the
setting.
 WDS Mode : Check WDS Mode button to enable AP mode, and then click “Save&Reboot” to activate the
setting.