User's Manual

User Manual
WCB1200H5PX Wireless High Power 5.8Ghz CPE
193
7.3.2 Wireless MAC Filter Setup
Continue 7.3.1 Repeater AP Setup section, the administrator can allow or reject clients to access Repeater AP.
MAC Filter Setup : By default, it’s “Disable”. Options are Disable, Only Deny List MAC or Only Allow List MAC.
Two ways to set MAC filter rules :
Only Allow List MAC.
The wireless clients in the “Enable” list will be allowed to access the Access Point; All others or clients in the
Disable” list will be denied.
Only Deny List MAC.
The wireless clients in the “Enable” list will be denied to access the Access Point; All others or clients in the
Disable” list will be allowed.
Add a station MAC : Enter MAC address (e.g. aa:bb:cc:00:00:0a) and click “Add” button, then the MAC address
should display in the “Enable” List.
There are a maximum of 20 clients allowed in this “Enable” List. The MAC addresses of the wireless clients can be added
and removed to the list using the Add and Remove buttons.
Click Reboot button to activate your changes
MAC Access Control is the weakest security approach.WPA or WPA2 security method is highly recommended.