User's Manual

User Manual
WCB1200H5PX Wireless High Power 5.8Ghz CPE
175
Chapter 7. Client Bridge + Universal Repeater Configuration
When Client Bridge+Universal Repeater mode is activated, the system can be configured as an Access Point and Client
Station simultaneously. This section provides information in configuring the Client Bridge+Universal Repeater mode with
graphical illustrations. WCB1200H5PX provides functions as stated below where they can be configured via a user-
friendly web based interface.
Option System Wireless Utilities Status
Operating Mode General Setup Profiles Settings System Overview
LAN Advanced Setup Firmware Upgrade Clients
Management Repeater AP Setup Network Utility Remote AP
Time Server Wireless Profile Reboot Extra Info
Functions
SNMP Site Survey Event Log
Table 7-1: Client Bridge+Universal Repeater Mode Functions
7.1 External Network Connection
7.1.1 Network Requirement
It can be used as an Client Bridge or Universal Repeater to receive and repeat wireless signal over last mile applications,
helping WISPs deliver wireless broadband Internet service to new residential and business customers. In this mode,
WCB1200H5PX is enabled with DHCP Server functions. The wired clients of WCB1200H5PX are in the same subnet
from Main Base Station and it accepts wireless connections from wireless client devices.
Figure 7-1 Client Bridge + Universal Repeater mode network Configuration
When the WCB1200H5PX configured as an Access Point and Client Station simultaneously, the Wireless
General and Advanced Setup also used simultaneously. But the Security Type can be different. In the other word,
the channel or other settings will be the same between WCB1200H5PX to Main Base Station and wireless client
to WCB1200H5PX, but security type can be different.