User's Manual

User Manual
WCB1200H5PX Wireless High Power 5.8Ghz CPE
128
6.2 Access Point Association
6.2.1 Configure Wireless General Setting
The administrator can change the data transmission, channel and output power settings for the system. Please click on
Wireless -> General Setup and follow the below setting.
Band Mode : Select an appropriate wireless band; bands available are 801.11a or 802.11a/n mixed mode.
Transmit Rate Control : Select the desired rate from the drop-down list; the options are auto or ranging from 6 to 54
Mbps for 802.11a
Country : US.
Tx Power : You can adjust the output power of the system to get the appropriate coverage for your wireless network.
Specify digit number between 1 to 100 (the unit is %) for your environment. If you are not sure of which setting to
choose, then keep the default setting, 100%.
When Band Mode select in 802.11a only mode, the HT(High Throughput) Physical Mode and 11n Configuration
settings should be hidden immediately.
Operating Mode : By default, it's Mixed Mode.
Mixed Mode : In this mode packets are transmitted with a preamble compatible with the legacy 802.11a/g, the
rest of the packet has a new format. In this mode the receiver shall be able to decode both the Mixed Mode
packets and legacy packets.
Green Field : In this mode high throughput packets are transmitted without a legacy compatible part.
Channel Bandwidth : The "Auto” MHz option is usually best. The other option is available for special circumstances.
Guard Interval : Using “Auto” option can increase throughput. However, it can also increase error rate in some
installations, due to increased sensitivity to radio-frequency reflections. Select the option that works best for your
installation.