User's Manual

User Manual
WCB1200H5PX Wireless High Power 5.8Ghz CPE
121
Chapter 6. CPE + AP Mode Configuration
When CPE+AP mode is chosen, the system can be configured as a Customer Premises Equipment(CPE). This section
provides detailed explanation for users to configure in the CPE+AP mode with help of illustrations. In the CPE+AP mode,
functions listed in the table below are also available from the Web-based GUI interface.
OPTION System Wireless Advance Utilities Status
Operating Mode General Setup DMZ Profiles Settings System Overview
WAN Advanced Setup IP Filter Firmware Upgrade Station Statistics
LAN Repeater AP Setup MAC Filter Network Utility Extra Info
DDNS Wireless Profile Virtual Server Reboot QoS Plot
Management Site Survey Parental Control Event Log
Time Server QoS
UPNP
Functions
SNMP
Table 6-1: CPE+AP Mode Functions
6.1 External Network Connection
6.1.1 Network Requirement
It can be used as an Outdoor Customer Premises Equipment (CPE) to receive and repeat wireless signal over last mile
application, helping WISPs deliver wireless broadband Internet service to residents and business customers. In the
CPE+AP mode, WCB1200H5PX is a gateway enabled with NAT and DHCP Server functions. The wired and wireless
clients connected to WCB1200H5PX are in different subnet from those connected to Main Base Station, and, in CPE+AP
mode, it accepts wireless connections from wireless client devices.
Figure 6-1 CPE+AP mode network configuration
When the WCB1200H5PX configured as an Access Point and Client Station simultaneously, the Wireless
General and Advanced Setup also used simultaneously. But the Security Type can be different. In the other
word, the channel or other settings will be the same between WCB1200H5PX to Main Base Station and
wireless client to WCB1200H5PX, but security type can be different.