User's Manual

User Manual
WCB1200H5PX Wireless High Power 5.8Ghz CPE
77
Chapter 5. CPE Mode Configuration
When CPE mode is chosen, the system can be configured as a Customer Premises Equipment(CPE). This section
provides detailed explanation for users to configure in the CPE mode with help of illustrations. In the CPE mode, functions
listed in the table below are also available from the Web-based GUI interface.
OPTION System Wireless Advance Utilities Status
Operating Mode General Setup DMZ Profiles Settings System Overview
WAN Wireless Profile IP Filter Firmware Upgrade Station Statistics
LAN Site Survey MAC Filter Network Utility Extra Info
DDNS Virtual Server Reboot QoS Plot
Management Parental Control Event Log
Time Server QoS
UPNP
Functions
SNMP
Table 5-1: CPE Mode Functions
5.1 External Network Connection
5.1.1 Network Requirement
It can be used as an Outdoor Customer Premises Equipment (CPE) to receive wireless signal over last mile application,
helping WISPs deliver wireless broadband Internet service to residents and business customers. In the CPE mode,
WCB1200H5PX is a gateway enabled with NAT and DHCP Server functions. The wired clients connected to
WCB1200H5PX are in different subnet from those connected to Main Base Station, and, in CPE mode, it does not
accept wireless association from wireless clients.
Figure 5-1 CPE mode network configuration