User's Manual

User Manual

WCB1200H5PX Wireless High Power 5.8Ghz CPE

4.4.3 Extra Information

Users could pull out information such as Route table, ARP table, MAC table, Bridge table or STP available in the drop-

down list from system. The “Refresh” button is used to retrieve latest table information.

 Route table information : Select “Route table information” on the drop-down list to display route table.

WCB1200H5PX could be used as a L2 or L3 device. It doesn’t support dynamic routing protocols such as RIP or

OSPF. Static routes to specific hosts, networks or default gateway are set up automatically according to the IP

configuration of system's interfaces. When used as a L2 device, it could switch packets and, as L3 device, it’s

capable of being a gateway to route packets inward and outward.

 ARP table Information : Select “ARP Table Information” on the drop-down list to display ARP table.

ARP associates each IP address to a unique hardware address (MAC) of a device. It is important to have a unique IP

address as final

destination to switch

packets to.

 Bridge table information : Select “Bridge Table information” on the drop-down list to display bridge table.

Bridge table will show Bridge ID and STP's Status on the each Ethernet bridge and its attached interfaces, the Bridge

Port should be attached to some interfaces (e.g. eth2, ra0 and wds0~wds3).